Filter
Top Products
Finding
a
Station
AM-FM:
Press the lower knob to get AM,
FM1
or
FM2.
The
display shows your selection.
TUNE:
Turn the lower knob to choose radio stations.
SEEK:
Press the forward or backward arrow to
go
to
the next hgher or lower station. The sound will be
muted while seeking.
SCAN:
Press one of the
SEEK
arrows for two seconds,
and SCAN will appear on the display. Use SCAN to
listen to stations for a few seconds. The radio will go to
a station, stop for a few seconds, then go on to the next
station. Press one of the
SEEK
arrows again to stop
scanning. The sound will be muted while scanning.
PUSHBUTTONS:
The six numbered pushbuttons
let you return to your favorite stations. You can set up to
18
stations (six AM, six FMl and six
FM2).
1.
Press AM-FM to select the band.
2. Find the station you want by using TUNE or
SEEK.
3.
Press and hold one of the six numbered buttons.
4.
The sound will mute. When
it
returns, release the
button. Whenever you press that numbered button,
the
station
you
set will return.
P
SCAN:
Press this button to listen to each
of
your preset
stations for a few seconds. The radio will go to the frst
preset station, stop
for
a few seconds, then
go
on to the
next preset station. Press P
SCAN
again
to
stop scanning.
The
radio will not stop at a preset if the station is weak.
Setting the Tone
BASS:
Press this knob lightly
so
it extends. Turn
the
knob to increase
or
decrease bass.
TREB:
Press this button lightly
so
it extends. Turn the
knob to increase or decrease treble.
Push the knobs back in when you’re not using them.
Adjusting
the
Speakers
BAL:
Turn the control behind the upper knob to move
the
sound to the left or right speakers. Use the middle
position to balance these speakers.
FADE:
Turn the control behind the lower knob to move
the sound to the front
or
rear speakers. Use the middle
position to balance these speakers.
3-11