Filter
Top Products
6. Projector Configuration
Image 6-3
Network settings window, Barco controller
6.2.3 Manually assign an Ethernet address
How to set up
1. Click on the BARCO button.
The Network se
ttings window will open. (image 6-4)
2. Check the check box next to Use the following IP address
3. Click in the inpu
t field of the IP address and fill out the 4 fields.
Note: An address contains 4 octets with a maximum value of 255.
This must NOT b e 0.0.0.0 for static IP-Address assignme nt
4. Click in the Subnet mask input fields and fill out the 4 fields as appropriate for the local subnet.
5. Click in the Default Gateway input fields and fill out the 4 fields. Set the Default-Gateway to the IP-Ad-
dress of the router (MUST be on the local subnet!).
Note: This must NOT be 0.0.0.0.
Ifthereisnoroute
r on the projector’s local subnet then just set this field to any IP-Address on
the subnet.
6. Click OK to activate.
R5976790 COMMUNICATOR 09/07/2004
41