Filter
Top Products
5. Adjustment
5.7.7 Auto Load Enabled
Whatcanbedone?
When this function is enabled, the ACSAR 2 will create by itself a new custom file when it detects a relevant
input signal.
How to enable ?
1. Click on Input File on the menu bar and check Auto Load Enabled (1).
A check mark will appear in the box just before the Auto Load Enabled item.
5.7.8 Image Settings
Overview
The following image settings can be adjusted depending on the source type :
• Contrast
• Brightness
•Phase
• Sharpness
• Saturation
When a setting is not adjustable, this setting will be grayed out.
Adjusting via dragging
1. Click on the slider bar of the specific adjustment. (image 5-29)
The complete slider bar will be selected within a rectangle.
2. Move the slider up or down until the desired value for that specific adjustment is reached.
The value below the adjustment will change accordingly.
Image 5-29
Adjusting via dragging
Adjusting via the up and down keys
1. Click on the up or down arrow keys until the desired value is reached.
The value next to the arrow keys will change accordingly.
Adjusting via the input box
1. Click inside the value input box.
2. Select the actual value and enter a new value with your keyboard.
R5976790 COMMUNICATOR 09/07/2004
35