Filter
Top Products
62
English
Basic Operation
Setting the Time and Date
Turn the ignition switch to the ON position.
A clock display will appear on the display.
Briefly toggle the Disarm/Valet switch to the
ON position.
Within 10 seconds, press the MODE button.
Date and Time Setup mode will be indicated
by a scrolling "DATE/TIME SETUP" message
on the display.
Note: This mode will timeout after 30
seconds of no activity.
Press and release the TX/PANIC button. The
hour will blink.
When the display is blinking, press and
release the EXT1/VALET or the EXT2/EXT3
button to change the hour.
EXT1/VALET button: UP
EXT2/EXT3 button: DOWN
Set the hour by pressing the TX/PANIC
button. The minute will blink.
1
2
3
ACC
OFF
ON
RUN
4
TX
PANIC
5
EXT 1
VALET
EXT 2
EXT 3
or/ou/o
6
TX
PANIC