Alpine SEC-8345 Automobile Alarm User Manual


 
30
English
Basic Operation
1
2
3
ACC
OFF
ON
RUN
VALET
Coded Disarm
For increased protection, a disarm code can
be registered into the SEC-8063 for manual
disarming. Please see page 116 for informa-
tion on registering the disarm code number.
The following shows how to disarm the
vehicle using the Coded Disarm feature.
Enter the vehicle. The security system will
sound the siren. Turn the ignition switch to
the ON position and make sure all doors are
closed.
Press the Disarm/Valet switch momentarily.
“CODED DISARM” will scroll on the Security
Display Module and "_ _ _ _" will appear
prompting you for the code.
Enter the digit using the Disarm/Valet switch.
Each time you toggle the Disarm/Valet
switch, the digit will increment up. To register
this digit, open, then close the door. The
system will advance to the next digit.
Note: The code number input mode is
terminated after a time (30 or 60 sec)
set in the Duration of Function Setup
menu.
Repeat step 3 until all digits have been
registered.
Note: The Coded Disarm code must be
registered before this function can be
used. Please see page 116 for further
information.
Notes:
If the code number entered is not
matched to the number registered,
“_ _ _ _ ” will be displayed. Enter the
correct number again.
If you forget the code number, consult with
the ALPINE dealer near to your home.
4
VALET