Alpine SEC-8345 Automobile Alarm User Manual


 
160
English
English/Français/Español
Remote Control
Transmitter
Battery Replacement
(SEC-8463)
Place the SEC-8463 on a flat surface with the
buttons facing downward. Remove the
battery case screws using a Phillips screw-
driver.
While holding the unit with the buttons facing
upward, remove the top cover by gently
lowering the bottom cover and pulling the top
cover toward you.
To remove the battery, insert a pointed object
onto the slot of the battery holder and lift the
battery.
Insert a new Lithium battery (#CR2032).
Make sure the battery polarity is correct.
Replace the top cover by inserting the upper
end first.
Tighten the screws.
Caution on use of the Remote Control
Transmitter
If the following condition is noticed while
using the Remote Control Transmitter, please
change its battery (#CR2032).
Range becomes extremely low.
Lithium Battery (#CR2032)
Pile au lithium (#CR2032)
Pila de litio (#CR2032)
1
2
3
Phillips Screwdriver
Tournevis Phillips
Destornillador Phillips
Battery Case Screw
Vis du compartiment à pile
Tornillo del compartimiento de
la batería
Battery Case
Compartiment à pile
Compartimiento de
la batería