Filter
Top Products
Chapter 1 ATCA-C110/1G Baseboard Preparation and Installation
ATCA-C110/1G Installation and Use Manual
11
REVIEW COPY
Removing SO-DIMM
To remove the SO-DIMM from the SO-DIMM socket on the ATCA-C110/1G follow these steps:
Step 1:Pull the two retaining clips of the SO-DIMM socket in an outward direction, parallel to the surface
of the board, as shown by arrows in Figure 1-8.
Step 2:The SO-DIMM will no longer be locked in position, but will be at an angle of 45°, shown in
Removing the SO-DIMM - slide module out on page 11. Pull the SO-DIMM outwards in the
direction of the arrow as shown below.
Step 3:The SO-DIMM is now removed from ATCA-C110/1G.
Figure 1-8. Removing the SO-DIMM - pull retaining clips outward
Figure 1-9. Removing the SO-DIMM - slide module out
45 Angle
0