The total amount of space allowed is 16 FP Blocks. System flow requires three
blocks and these blocks cannot be reallocated. The ipv4acl profile range is from
1 to 4.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which
is from 0 to 10. The
ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).
If you enabled BMP, to perform a reload on the chassis to upgrade any
configuration changes that have changed the NVRAM content, use the reload
conditional nvram-cfg-change
command.
clear line
Reset a terminal line.
Syntax
clear line {line-number | aux 0 | console 0 | vty number}
Parameters
line-number Enter a number for one of the 12 terminal lines on the
system. The range is from 0 to 11.
aux 0 Enter the keywords aux 0 to reset the auxiliary port.
console 0 Enter the keywords console 0 to reset the console port.
vty number Enter the keyword vty then a number to clear a terminal
line. The range is from 0 to 9.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
Control and Monitoring
95
