Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Related
Commands
match interface — redistributes routes that match the next-hop interface.
match ip address — redistributes routes that match an IP address.
match ip route-source — redistributes routes that match routes advertised by other
routers.
match metric — redistributes routes that match a specific metric.
match route-type — redistributes routes that match a route type.
match tag — redistributes routes that match a specific tag.
match ip route-source
To match based on the routes advertised by routes specified in IP access lists or IP prefix lists, configure a
filter.
Syntax
match ip route-source {prefix-list prefix-list-name}
To delete a match, use the no match ip route-source {prefix-list
prefix-list-name} command.
Parameters
prefix-list
prefix-list-
name
Enter the keywords prefix-list and then enter the name
of configured prefix list, up to 140 characters.
Defaults Not configured.
Command
Modes
ROUTE-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Access Control Lists (ACL)
251
