number that is specified as the export route target at the
source VRF.
route-map-
name
Enter the name of the route-map to filter the imported
routes.
NOTE: You must use the route-map attribute while
importing routes from the global RTM. Route-maps
enable you to filter routes at the import end based on
the matching criteria that you define in the route-map.
Defaults N/A
Command
Modes
VRF MODE
CONFIGURATION
Command
History
Version Description
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–
ON, and Z9500.
Usage
Information
It is possible to configure multiple import conditions per VRF depending on the
exporting VRF.
The export-target and import-target support only the match protocol and match
prefix-list options. Other options that are configured in the route-maps are
ignored.
Related
Commands
ipv6 route-export – exports IPv6 routes to another VRF.
match source-protocol
Enables you to specify matching criteria while exporting or importing routes.
Syntax
match source-protocol {bgp | isis | ospf | connected | static}
Parameters
bgp Enter the keyword bgp to leak or share routes corresponding
to the BGP protocol.
isis Enter the keyword isis to leak or share routes corresponding
to the ISIS protocol.
ospf Enter the keyword ospf to leak or share routes
corresponding to the OSPF protocol.
connected Enter the keyword connected to leak or share connected
routes corresponding to the VRF.
1614
Virtual Routing and Forwarding (VRF)
