Queueing strategy: fifo
Time since last interface status change: 00:05:12
Related
Commands
show interfaces configured – displays any interface with a non-default
configuration.
show interfaces switchport – displays Layer 2 information about the interfaces.
show inventory (S-Series and Z-Series) – displays the S-Series and Z-Series switch
types, components (including media), Dell Networking OS version including
hardware identification numbers, and configured protocols.
show range – displays all interfaces configured using the interface range
command.
show interfaces configured
Display any interface with a non-default configuration.
S6000
Syntax
show interfaces configured
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Changed the organization of the display output.
Example
Dell#show interfaces configured
TenGigabitEthernet 13/18 is up, line protocol is up
Hardware is Force10Eth, address is 00:01:e8:05:f7:fc
Current address is 00:01:e8:05:f7:fc
Interface index is 474791997
Internet address is 1.1.1.1/24
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 1000 Mbit, Mode full duplex, Master
Interfaces
707
