M Te 1/18
M Te 1/6
Dell#
vlan-stack dot1p-mapping
Map C-Tag dot1p values to a S-Tag dot1p value. You can separate the C-Tag values by commas and
dashed ranges are permitted. Dynamic mode CoS overrides any Layer 2 QoS configuration in case of
conflicts.
Syntax
vlan-stack dot1p-mapping c-tag-dot1p values sp-tag-dot1p value
Parameters
c-tag-dot1p
value
Enter the keyword c-tag-dot1p then the customer dot1p
value that is mapped to a service provider do1p value. The
range is from 0 to 7.
sp-tag-dot1p
value
Enter the keyword sp-tag-dot1p then the service provider
dot1p value. The range is from 0 to 7.
Defaults none
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced on the C-Series and S-Series.
vlan-stack protocol-type
Define the stackable VLAN tag protocol identifier (TPID) for the outer VLAN tag (also called the VMAN
tag). If you do not configure this command, Dell Networking OS assigns the value 0x9100.
Syntax
vlan-stack protocol-type number
1602
VLAN Stacking
