• ethertype — Use Ethertype field in hash calculation.
• source-dest-mac — Use SMAC and DMAC fields in hash
calculation.
tunnel [ipv4-
over-ipv4 |
ipv4-over-gre-
ipv4 | mac-in-
mac]}
To use tunnel key fields in hash computation, enter the
keyword tunnel then one of the parameters:
• ipv4-over-ipv4 — Use ipv4-over-ipv4 field in hash
calculation.
• ipv4-over-gre-ipv4 — Use ipv4-over-gre-ipv4 field in
hash calculation.
• mac-in-mac — Use mac-in-mac field in hash calculation.
Defaults IP selection 5-tuples (source-ip dest-ip vlan protocol L4-source-port L4-dest-
port).
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Added support for IPv6.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
management route
Configure a static route that points to the Management interface or a forwarding router.
S6000
Syntax
management route {{ip-address mask | {ipv6-address prefix-
length}} {forwarding-router-address | managementethernet |
fortyGigE | vlan | tengigabitethernet}
To remove a static route, use the no management route{{ip-address mask
| {ipv6-address prefix-length}}{forwarding-router-address |
784
IPv4 Routing
