Command
History
Version 9.0.2.0 Introduced on the S6000.
Example
BOOT_USER # boot write net config retries 2
Updated number of Network Boot Config retries to 2
BOOT_USER #
boot zero
Erase the configured primary, secondary, or default boot image parameters. If you erase all three
parameters, the S6000 switch boots from its internal Flash.
S6000
Syntax boot zero primary | secondary | default}
Parameters
primary
Enter the keyword primary to configure the boot parameters
used in the first attempt to boot the system.
secondary
Enter the keyword secondary to configure boot parameters
used if the primary operating system boot selection is not
available.
default
Enter the keyword default to configure boot parameters
used if the secondary operating system boot parameter
selection is not available. You can configure this option to
any of the available type, for example flash/usb/ftp/tftp.
Defaults None
Command
Modes
BOOT_USER
Command
History
Version 9.0.2.0 Introduced on the S6000.
Usage
Information
This command reverses changes made with the boot change command.
BOOT_USER # boot zero primary
BOOT_USER # boot zero secondary
BOOT_USER # boot zero default
BOOT_USER # show bootvar
PRIMARY OPERATING SYSTEM BOOT PARAMETERS:
326
Boot Command Line Interface
