• linkdown
• linkup
Defaults Not enabled.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
9.1(0.0) Added support for copy-config and ecmp traps.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.4.1.0 Added support for VRRP traps.
7.6.1.0 Added support for STP and xSTP traps. Introduced on the S-
Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
Dell Networking OS supports up to 16 SNMP trap receivers.
If you do not configure this command, no traps controlled by this command are
sent. If you do not specify a notification-type and notification-option,
all traps are enabled.
Related
Commands
snmp-server community — enables SNMP and sets the community string.
snmp-server engineID
Configure the name for both the local and remote SNMP engines on the router.
Syntax
snmp-server engineID [local engineID] [remote ip-address vrf
vrf-name udp-port port-number engineID]
1484
Simple Network Management Protocol (SNMP) and Syslog
