trigger detail tied to the VRF that you specify. When SPF is
triggered, this debugging information is displayed.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other
platforms,refer to the relevant Dell Networking OS Command Line Reference
Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
6.3.1.0 Introduced.
debug isis update-packets
Enable debugging on link state PDUs (LSPs) that a router detects.
S6000
Syntax
debug isis [vrf vrf-name] update-packets [interface]
To turn off debugging, use the no debug isis update-packets
[interface] command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to enable the debugging information on IS-IS. This
information contains updates from neighbors tied to the VRF
that you specify. This command displays the debugging
details of the received LSPs from the neighbors.
interface (OPTIONAL) Identifies the interface type slot/port as one of
the following:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a port channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
850
Intermediate System to Intermediate System (IS-IS)
