Version Description
9.5(0.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the C-Series for the port-channels and the S-
Series.
7.7.1.0 Introduced on the E-Series.
Example
Dell(conf)# ip access-list extended iptv-channels
Dell(config-ext-nacl)# permit ip 10.1.2.3/24 225.1.1.0/24
Dell(config-ext-nacl)# permit ip any 232.1.1.0/24
Dell(config-ext-nacl)# permit ip 100.1.1.0/16 any
Related
Commands
ip access-list extended — configure an access list based on IP addresses or
protocols.
ip pim neighbor-filter
To prevent a router from participating in protocol independent multicast (PIM), configure this feature.
S6000
Syntax
ip pim [vrf vrf-name] neighbor-filter {access-list}
To remove the restriction, use the no ip pim [vrf vrf-name] neighbor-
filter {access-list} command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to prevent that VRF from participating in PIM.
NOTE: Applies to specific VRF if input is provided, else
applies to default VRF.
access-list Enter the name of a standard access list. Maximum 16
characters.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1194
PIM-Sparse Mode (PIM-SM)
