Command
Modes
ROUTER OSPF
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support for the Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Usage
Information
The distribute-list out command applies to routes autonomous system
boundary routers (ASBRs) redistributes into OSPF. It can be applied to external type
2 and external type 1 routes, but not to intra-area and inter-area routes.
fast-convergence
This command sets the minimum LSA origination and arrival times to zero (0), allowing more rapid route
computation so that convergence takes less time.
S6000
Syntax
fast-convergence {number}
To cancel fast-convergence, use the no fast convergence command.
Parameters
number Enter the convergence level desired. The higher this
parameter is set, the faster OSPF converge takes place. The
range is from 1 to 4.
Defaults none.
Command
Modes
ROUTER OSPF
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1076
Open Shortest Path First (OSPFv2 and OSPFv3)
