arp inspection-trust
Specify a port as trusted so that ARP frames are not validated against the binding table.
S6000
Syntax
arp inspection-trust
Defaults Disabled
Command
Modes
• INTERFACE
• INTERFACE PORT-CHANNEL
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced on the E-Series.
8.2.1.0 Introduced on the C-Series and S-Series.
Related
Commands
arp inspection — enables dynamic ARP inspection on a VLAN.
clear ip dhcp snooping
Clear the DHCP binding table.
Syntax
clear ip dhcp snooping {binding | source-address-validation
discard-counters [interface interface]}
Parameters
binding
Clears the binding table.
source-
address-
validation
discard-
counters
Clears discard counters from all the interfaces configured
with IP Source Guard.
560
Dynamic Host Configuration Protocol (DHCP)
