Filter
Top Products
37
While navigating a route, these elds show the estimated time needed to reach the
destination (ETE), the distance to destination, and the estimated arrival time at the
destination (ETA) by default.
You can choose what to display in these three elds during navigation, by going to
Advanced settings / Display Options (Page 66). See the following list for your options.
The only restriction is that you cannot select a value that already appears in another
eld. The possible eld contents are:
• Distance to destination (default value for the left eld)
• Time to destination (estimated time en route, default value for the middle eld)
• Distance to next via point
• Time to next via point
• Time to next manoeuvre (next route event)
• Speed
• Speed limit
• Arrival at next via point
• Arrival at destination (default value for the right eld)
4.5.16 Distance to next turn (No. 18)
This eld shows the distance to go before reaching the next route event (turn,
roundabout, exit, etc.)
This eld is only displayed when navigating a route.
4.5.17 Next street / Next settlement (No. 19)
This eld shows the road or street that comes next in the route itinerary.
If you are not yet in the settlement where this next street is, Uniden Navigation will
display the name of the settlement instead of the name of the road or street. A bullet
symbol will appear next to the name of settlements to help you tell them apart from
street names.
This eld is only displayed when navigating a route.