Filter
Top Products
Installation
20221032B 73
4.4 Determining System Configuration
It is important to become familiar with the configuration of the
system prior to beginning the installation. The AP50 Basic
system is shown in Figure 1-1 on page 13 and an extended
system is shown in Figure 4-1 on page 73.
Pay particular attention to the junction unit/drive unit
combinations on page 89 and the junction units chart on page
14.
As many of the units are communicating on a common network
(RobNet) with identical connectors, the installation is simplified.
Mount the units within the standard cable length supplied with
each unit, if possible (refer to Technical Specifications, section
3, beginning on page 49. RobNet Extension Cable (10m) is
available from your Simrad distributor. Refer to the Spare Parts
List on page 170 for part numbers.
4.5 AP50 System Layout
AD50
SOLENOID
VALVE
RF45X
S100
AP51
AP50
CDI35
NMEA DATA
EXT. ALARM
CD100A
AP50
S35
ELECTRONIC
CHART
SYSTEM
WINDVANE
HS50
RF300S
R3000X
GI UNIT
(future option)
GI50
2-WIRE FREQ.
MAINS
3- or 4-WIRE
CI300X
** STEPPER GYRO, GEARED SYNCHRO GYRO, PULSE-LOG
* SYNCHRO 1:1, CD100A, SINE/COSINE MAGNETIC COMPASS
FU50
F1/2 NFU
RFC35R
(Alternative
connection)
BOAT'S
MAGNETIC
COMPASS
NI300X
GPS/
CHART
PLOTTER
NON
SIMRAD
COMPASS
RC25/RFC35R
RADAR CLK/DATA
2-WIRE FREQ.
ROBNET
TI50
J50/
J50-40
RI35 MK2
GYROCOMPASS
REVERSIBLE
PUMP
RF14XU
Figure 4-1 AP50 Extended system with options
Note ! The extended system layout does not show all possible layouts.