Filter
Top Products
Software Set-up Procedure
20221032B 135
Set Thrust Direction, On/Off Thruster
(ONLY IF ON/OFF THRUSTER IS SELECTED, proceed to
page 136 if continuous thruster or Danfoss thruster is selected)
No
Yes
SEATRIAL
Compass Flux1
Calibration
Offset +005°
Heading 288°
Set thrust direction
Speed source Man
Set cruising speed 15kt
P S
Adjust?
SEATRIAL
Set thrust direction
STBD
Rotate the course knob clockwise to activate the Set thrust
direction setting.
Rotate the course knob to starboard and verify that the vessel
turns to starboard. The thruster stops after 10 seconds, or when
the
(STBD) button is pressed.
If the boat turns to port when the course knob is turned to
starboard, rotate the knob to port to ensure a starboard turn.
This tells the autopilot which direction to turn the thruster.
For ON/OFF thrusters, a change in direction command will
always be delayed 1 second to prevent thruster breakage.
Note ! If advanced set-up of the thruster is required, refer to the
SETTINGS menu on page 156.
Proceed to the “Speed source” item on page 137 by pressing the
(STBD) button or return to STANDBY mode by pressing the
STBY
(STBY) button.
Thruster Calibration, Analog Thruster
SEATRIAL
Compass Flux1
Calibration
Offset +005°
Heading 288°
Thruster CAL
Speed source Man
Set cruising speed --kt
No
Yes
SEATRIAL
Thruster zero 00%
Maximum thrust STBD ---%
Maximum thrust PORT ---%
Minimum thrust 00%
(ONLY IF CONTINUOUS THRUSTER OR DANFOSS
THRUSTER IS SELECTED)
Rotate the course knob clockwise to select the Thruster CAL
display.
Thruster zero
Rotate the course knob until you have no output effect from the
thruster. The Thruster zero offset is now set.
Range: -50% to +50% in step of 1%.
Default: 0%.
Proceed to the Maximum thrust STBD item by pressing the
(STBD) button.