Filter
Top Products
Each touch of [AV2 Input] changes the set-
ting as follows:
! Off— No video component is connected
! Video— External video component
p Use AV2 Input when connecting CD-RM10
(sold separately) through the external video
component.
Switching the auto antenna
setting
If the blue lead of the navigation system is
connected to the antenna control terminal of
the vehicle, select either of the following set-
tings.
! Radio — The antenna extends or turns on
only when the audio source is FM or AM.
The antenna is stored or turned off when
the AV source is switched to another
source.
! Power — The antenna extends or turns on
when the ignition switch is turned on. The
antenna is stored or turned off when the
ignition switch is turned off.
% Touch [Ant CTRL] on the “AV System
Settings” menu.
= For details, refer to Displaying the “AV Sys-
tem Settings” menu on the previous page.
Touching [Ant CTRL] switches between
[Radio] and [Power].
p Regardless of whether [Radio]or[Power]
is selected, turning off the ignition switch
will cause the antenna to automatically re-
tract or turn off.
Changing the wide screen mode
% Touch [Wide Mode] on the “AV System
Settings” menu.
= For details, refer to Displaying the “AV Sys-
tem Settings” menu on the previous page.
Each touch of [Wide Mode] changes the set-
ting as follows:
Full — Normal
Full (full)
A 4:3 picture is enlarged in the horizontal di-
rection only, enabling you to enjoy a 4:3 TV pic-
ture (normal picture) without any omissions.
Normal (normal)
A 4:3 picture is displayed normally, giving you
no sense of disparity since its proportions are
the same as that of the normal picture.
p Different settings can be stored for each
video source.
p The same setting is automatically applied
for the following grouping.
! SD,USB, iPod
! AV1 and AV2
! EXT1and EXT2
p When video is viewed in a wide screen
mode that does not match its original as-
pect ratio, it may look strange.
p Remember that use of this system for com-
mercial or public viewing purposes may
constitute an infringement on the author’s
rights protected by the Copyright Law.
p The navigation map and the rear view cam-
era picture is always viewed at Full.
Switching the sound muting/
attenuation
You can select the muting method when the
navigation guidance is output. This setting is
also effective for a mute signal that has been
received from the MUTE lead connected to the
navigation system.
p When you use a cellular phone connected
with Bluetooth technology (dialing, talking,
incoming call), the AV source volume is al-
ways muted independently of this setting.
p When the voice recognition mode is acti-
vated, the AV source volume is always
muted independently of this setting.
% Touch [MUTE Input/GUIDE] on the “AV
System Settings” menu.
= For details, refer to Displaying the “AV Sys-
tem Settings” menu on the previous page.
Each touch of [MUTE Input/GUIDE] changes
the setting as follows:
! MUTE— Muting
Customizing preferences
En
165
Chapter
25
Customizing preferences