Filter
Top Products
PiN 570 | User Manual
19
8. Positioning the PiN in a Vehicle
Before you begin, determine whether your vehicle is fitted with a heat-reflecting or heated
windscreen. If so, you will need to purchase an external antenna for your PiN to receive GPS
signals.
Read the Safety Notice on page 6 to ensure that the PiN does not obstruct the driver’s view, or
interfere with the operation of vehicle airbags and safety devices.
Installing the PiN in Your Vehicle
First, check the Hard Reset on the bottom of the PiN. If the button is to the left, then remove the
stylus and use it to move the switch to the right.
Choose a suitable position on the windshield where the PiN will be clearly visible by the driver
without obstructing the view of the road. Clean and dry the suction-cup and the windshield. Do
not touch either area after it is cleaned.
1.
Insert the four tabs at the end of the suction-mount arm into the four slots on the PDA
cradle. Ensure that the Close arrow on the suction-mount is pointed toward the top
end of the cradle.
2.
Slide the suction-mount arm towards the top of the PDA cradle. The cradle should
click into place.
3.
Ensure that a memory card has been placed in the PiN’s memory card slot.
See page 17
for detailed instructions on how to insert the memory card.
4.
Open the GPS antenna outwards, so that it has a clear view of the sky.
5.
Close the side-arms of the PDA cradle so that the PiN is held securely in place.