Filter
Top Products
www.mivec.co.nz
4G9 ENGINE (E–W) – Water Pump and Water Hose
11A-7-5
PWEE9502-B
E
Nov. 1996Mitsubishi Motors Corporation
Revised
INSTALLATION SERVICE POINTS
"AA WATER PUMP INSTALLATION
(1) Apply 3 mm diameter of Form-In-Place Gasket (FIPG)
to the location shown in the illustration.
Specified sealant:
Mitsubishi Genuine Part No.MD970389 or
equivalent
"BA WATER INLET PIPE <FRONT WHEEL
DRIVE>/WATER PIPE <REAR WHEEL
DRIVE>/O-RING INSTALLATION
(1) Replace the O-ring of the water inlet pipe <FRONT WHEEL
DRIVE> or water pipe <REAR WHEEL DRIVE>, and then
apply water to the O-ring to make installation easy.
Caution
1. Never apply any oil or grease to the O-ring.
2. Secure the water pipe after the thermostat case
has been installed.
"CA THERMOSTAT CASE INSTALLATION
(1) Apply 3 mm diameter of Form-In-Place Gasket (FIPG)
to the location shown in the illustration.
Specified sealant:
Mitsubishi Genuine Part No.MD970389 or
equivalent
"DA THERMOSTAT INSTALLATION
(1) Install the thermostat so that the jiggle valve is facing
straight up.
"EA WATER OUTLET FITTING INSTALLATION
(1) Apply 3 mm diameter of Form-In-Place Gasket (FIPG)
to the location shown in the illustration.
Specified sealant:
Mitsubishi Genuine Part No.MD970389 or
equivalent
PWEE9502-K
E
Jun. 2002Mitsubishi Motors Corporation Revised
Jiggle valve
<FRONT WHEEL DRIVE>