Filter
Top Products
www.mivec.co.nz
4G9 ENGINE (E–W) – Front Case and Oil Pump
11A-10-6
PWEE9502
E
May 1995Mitsubishi Motors Corporation
(4) Tighten the lower oil pan mounting bolts in the sequence
shown in the illustration.
"EA OIL FILTER INSTALLATION
(1) Clean the filter installation surface of the cylinder block.
(2) Apply engine oil to the O-ring of the oil filter.
(3) Screw in the oil filter until its O-ring comes in contact
with the base. Then tighten one more turn.
"FA SEALANT APPLICATION TO OIL PRESSURE
SWITCH
(1) Apply sealant to the threads of the switch.
Specified sealant:
3M ATD Part No. 8660 or equivalent
Caution
Use care not to allow the sealant to plug the oil
passage.
INSPECTION 11300730026
OIL PUMP
(1) Check the tip clearance.
Standard value: 0.06 – 0.18 mm
PWEE9502-K
E
Jun. 2002Mitsubishi Motors Corporation Revised
<Except for PAJERO io>
<For PAJERO io>
7
6
3
2
9
8
5
4
1
10
Oil passage