Filter
Top Products
www.mivec.co.nz
4G9 ENGINE (E-W) -
Timing belt
11A-4-4
PWEE9502
E
May 1995Mitsubishi Motors Corporation
"
B
A
TIMING BELT TENSIONER INSTALLATION
(1) Let the pulley of the timing belt tensioner comr closest
to the exhaust side. Temporarily tighten the tensioner
pulley fixing bolt.
"
C
A
TENSIONER SPRING INSTALLATION
(1) Insert the tip A (shorter one) of the tensioner spring into
the oil pump case.
(2) Use pliers or similar tool to pinch the tip B (longer one),
and then hook it to the tensioner bracket arm.
"
D
A
TIMING BELT INSTALLATION
(1) Turn the crankshaft sprocket by three teeth from the timing
mark.
Caution
Aligning the timing marks positions the piston to the
top dead centre.Then, if the camshaft turns, the valves
may hit and damage the pistons.
(2) Check that the timing belt tensioner and tensioner spring
are installed correctly. (Refer to the service points B and
C.)
(3) Align the timing marks on the camshaft sprocket to that
on the cylinder head.
(4) Align the timing mark on the crankshaft sprocket to that
on the oil pump case.
(5) Place the timing belt over the sprocket according in the
following order.
1. Crankshaft sprocket
2. Water pump sprocket
3. Camshaft sprocket
4. Tension pulley
Exhaust
side
Tensioner
pulley fixing
bolt
Tensioner
“A”
“B”
Pliers
Timing mark
Timing marks