Filter
Top Products
www.mivec.co.nz
4G9 ENGINE (E–W) – Alternator and Ignition System
11A-3-7
PWEE9502-A
E
Nov. 1995Mitsubishi Motors Corporation
REMOVAL SERVICE POINT
AA" CRANKSHAFT BOLT REMOVAL
(1) Use the special tool to hold the flywheel or the drive
plate, and then loosen the crankshaft mounting bolts.
INSTALLATION SERVICE POINTS
"AA CAM POSITION SENSOR SUPPORT
INSTALLATION
(1) Apply a 3 mm bead of form-in-place gasket (FIPG) to
the area shown.
Specified sealant:
Mitsubishi Genuine Part No. MD970389 or
equivalent.
"BA FRONT FLANGE / CRANKSHAFT PULLEY /
CRANKSHAFT BOLT INSTALLATION
(1) Use the special tool to hold the flywheel or the drive
plate.
(2) Clean and then degrease the front flange contacting
surface of the crankshaft pulley.
NOTE
Degreasing is necessary to prevent decrease in the friction
between contacting surfaces.
(3) Clean the bolt hole in the crankshaft, the crankshaft
contacting surface and washer contacting surface of the
crankshaft pulley, and the washer.
(4) Apply an appropriately small amount of oil to the threads
and seating surface of the crankshaft bolt.
(5) Tighten the crankshaft bolt to the specified torque of 182
± 4 Nm.
PWEE9502-K
E
Jun. 2002Mitsubishi Motors Corporation Revised
MD998781
MD998781
Crankshaft bolt
Crankshaft pulley
Front flange
Crankshaft
Degrease
Clean
Washer
Big chamfered side