Filter
Top Products
www.mivec.co.nz
4G9 ENGINE (E-W) -
Front Case and Oil Pump
11A-10-4
REMOVAL SERVICE POINTS
A
A
"
OIL PAN REMOVAL
(1) Knock in the special tool deeply between the oil pan
and the cylinder block.
(2) Hitting the side of the special tool, slide the special tool
along the oil pan to remove the oil pan.
A
B
"
REMOVAL OF UPPER OIL PAN
(1) At first remove the bolt (Length: 121 mm <DOHC,
DOHC-GDI for CARISMA>, 116 mm <DOHC-GDI for
PAJERO io>) which is nearest to flywheel, and the remove
the other bolts.
Caution
Never use the special tool (oil pan remover), etc.
A
C
"
OUTER ROTOR/INNER ROTOR REMOVAL
(1) Make alignment dots on the outer and inner rotors for
reference in reassembly.
INSTALLATION SERVICE POINTS
"
A
A
INNER ROTOR/OUTER ROTOR INSTALLATION
(1) Apply engine oil to the rotors. Then, install the rotors
ensuring that the alignment dots made at disassembly
are properly aligned.
"
B
A
SEALANT APPLICATION TO OIL PUMP CASE
Specified sealant:
Mitsubishi Genuine Part No. MD970389 or
equivalent
PWEE9502-E
E
Dec. 1998MitsubishiMotors Corporation Revised
MD998727
MD998727
Alignmentdots
Alignmentdots
3 mm diameter
bead sealant