Filter
Top Products
www.mivec.co.nz
4G9 ENGINE (E-W) -
Timing Belt
11A-4-6
PWEE9502-A
E
Nov. 1995MitsubishiMotors Corporation Revised
"
F
A
TIMING BELT INSTALLATION
(1) Make sure that the auto-tensioner is installed properly.
(Refer to service point F.)
(2) Align the timing mark on each sprocket with the
corresponding mark on th e timing belt.
(3) Turn the crankshaft sprocket one half the tooth width
counterclockwise.
(4) Fit the timing belt to the intake camshaft sprocket an d
secure with a paper clip at the illustrated position.
(5) Use two wrenches to fit the timing belt to the exhaust
sprocket while aligning th e timing marks.
Timing marks
Timing mark
Paper clip
Timing mark
Timingmark