Filter
Top Products
www.mivec.co.nz
4G9 ENGINE (E-W) -
Timing Belt
11A-4-9
PWEE9502
E
May 1995Mitsubishi Motors Corporation
(6) Abnormal wear of belt sides. The sides are normal if
they are sharp as if cut by a knife.
(7) Abnormal wear on teeth.
(8) Missing tooth.
TENSIONER PULLER, IDLER PULLEY
(1) Check the pulley for smooth rotation, excessive play,
abnormal noise. Replace it if necessary.
AUTO-TENSIONER
(1) Check the tensioner for oil leaks. Replace it if necessary.
(2) Check the rod en d for wear or damage. Replace the
tensioner if necessary.
(3) Measure the rod projection length. If not within the
standard value, replace the tensioner.
Standard value: 11 mm
(4) Press the rod by a force of 98 to 196 N and measure
the rod stroke. If not within the standard value, replace
the tensioner.
Standard value: 1 mm or less
Rounded edge
Abnormal wear
(Fluffy strand)
Rubber exposed
Tooth missing
and canvas
fiber exposed
11 mm
98 to 196 N
Stroke