Filter
Top Products
position $ or c, the daytime running
lamps are switched on when the engine is
running.
In low ambient light conditions the following
lamps will come on additionally:
R
Low-beam headlamps
R
Parking lamps
R
Tail lamps
R
License plate lamps
R
Side marker lamps
For more information on the daytime running
lamp mode, see (Y page 251).
i
Make sure the exterior lamp switch is set
to M or c when you switch off the
daytime running lamps while driving at
night.
For safety reasons, resetting all the functions
of all submenus to the factory settings while
driving (Y page 282) will not deactivate the
daytime running lamp mode.
The following message appears in the
multifunction display:
Cannot Be Completely Reset to
Factory Settings while Driving. .
Adjusting illumination brightness for
display and switches
Use this function to adjust the brightness of
the multifunction display and switches.
X
Press button = or ; to select the
Settings menu.
X
Press button : or 9 to select the
Lights submenu.
X
Press button a.
X
Press button : or 9 to set the
Brightness Display/Switches: .
The setting Level 10 represents the darkest
level and setting Level 100 the brightest
level. The brightness is switched off at setting
Level 0.
Switching locator lighting on or off
With the Locator Lighting: function
activated and the exterior lamp switch in
position c
R
the exterior lamps will come on during
darkness when the vehicle is unlocked with
the SmartKey.
The lamps will go out when the driver’s door
is opened.
If you do not open the driver’s door after
unlocking the vehicle with the SmartKey,
the lamps will go out automatically after
approximately 40 seconds.
R
the exterior lamps will remain on for
15 seconds during darkness after exiting
the vehicle and closing all doors.
If, after turning off the engine, you do not
open or close a door, the lamps will
automatically go out after 60 seconds.
The following lamps will come on
R
Parking lamps
R
Tail lamps
R
License plate lamps
R
Side marker lamps
X
Press button = or ; to select the
Settings menu.
X
Press button : or 9 to select the
Lights submenu.
X
Press button a.
X
Press button : or 9 to select the
Locator Lighting: function.
The current setting Enabled or Disabled
is shown.
Control system
285
Controls in detail
BA 197 USA, CA Edition A 2011; 1; 27, en-US
hereepe Version: 3.0.3.5
2010-03-24T15:31:10+01:00 - Seite 285
Z