Filter
Top Products
Example display with main destination and
stopover destination
1
Distance/estimated time of arrival/
estimated journey time to the stopover
destination
2
Stopover destination =
3
Main destination
4
Distance/estimated time of arrival/
estimated journey time to the main
destination <
i
When calculating the estimated time of
arrival, COMAND uses the time set on the
COMAND as its basis. For this reason, the
time on COMAND must be set correctly
(Y page 93). The calculation of the
estimated time of arrival does not
specifically take into consideration
whether it is daylight saving time or
standard time at the destination. It is not
taken into consideration whether or not the
destination is in a different time zone. The
distance to the destination, the estimated
time of arrival and the estimated remaining
journey time 1, 4 are not displayed until
the route calculation is complete.
X
To close the destination information:
Slide o m p.
or
X
Press the k button.
Navigation (Traffic Messages)
i
Optional satellite radio equipment and a
subscription to SIRIUS XM Satellite Radio
service provider are required for the
satellite radio reception referred to here.
You can find more information on SatRadio
in chapter “Satellite Radio” (Y page 221).
COMAND can receive and incorporate traffic
messages via satellite radio into the
navigation system. Traffic report messages
and map symbols can then be viewed in the
COMAND display.
Real-Time Traffic Notifications in the
Map
COMAND can display certain traffic events in
the map. The notifications are shown in the
map scale range from 0.05 mi to 20 mi.
X
Rotate y m z until the required map scale
is set when the menu system is hidden
(map in full-screen mode) (Y page 106).
1
Marker symbols for the extension of the
affected route section
2
Symbol for event on the route (speed and
flow)
3
Destination
4
Map scale
Navigation (Traffic Messages)
139
COMAND APS
BA 197 USA, CA Edition A 2011; 1; 27, en-US
hereepe Version: 3.0.3.5
2010-03-24T15:31:10+01:00 - Seite 139
Z