Filter
Top Products
t
Where would you like to save: home or
work?
s
Work
t
The destination has been saved.
“Find Address”
You can use the “Find address” command to
select a previously saved address and start
route guidance.
Example of dialog:
s
Find address
t
Please say the name
s
Smith
u
The system shows a numbered list of
saved addresses in the display
t
Please select a line number
s
Line number 1
t
Line number 1 accepted
t
Smith. Starting route guidance.
“Start Route Guidance”
When Route Guidance is inactive, you can use
the “Start route guidance” command to start
route guidance once a valid destination has
been entered.
s
Start route guidance
t
Starting route guidance
“Route Information”
You can use the “Route information”
command to have the following information
on your currently planned route read out:
R
Distance to destination
R
Remaining driving time
R
Expected arrival time
“Guidance Instructions On”
When you use the “Guidance instructions on”
command, voice control repeats the last
driving tip. If the driving tip output has been
switched off up to this point, it is now
switched on again.
“Guidance Instructions Off”
You can use this command to switch off the
route guidance voice output.
“Cancel Route Guidance”
You can use this command to stop route
guidance.
Example of dialog:
s
Cancel route guidance
t
Are you sure you want to cancel route
guidance?
s
Yes
t
Cancelling route guidance
Voice control cancels route guidance.
or
s
No
t
Continuing route guidance.
The dialog with voice control is terminated.
Route guidance remains activated.
“Zoom In”/“Zoom Out”
You can use these commands to zoom the
map display one step in or out.
“Zoom In Completely”/“Zoom Out
Completely”
You can use these commands to set the map
display directly to the smallest or largest
scale.
“Read Out Destination Memory”
You can use the “Read out destination
memory” command to listen to the entries
from the address book’s destination memory
and, if required, navigate to one of them.
Example of dialog:
s
Read out destination memory
The system reads out all entries, from
the address book destination memory.
If the list contains more than 30
entries, the system asks you to say the
name from which the reading shall be
started.
i
If you do not say a name, voice control
reads out all destination entries.
Voice Control
217
COMAND APS
BA 197 USA, CA Edition A 2011; 1; 27, en-US
hereepe Version: 3.0.3.5
2010-03-24T15:31:10+01:00 - Seite 217
Z