Filter
Top Products
Replacing wiper blades
359
Bulb carrier
3
Side marker lamp
4
Rear fog lamp (driver’s side only), side
marker lamp
5
Backup lamp
6
Tail lamp, brake lamp
7
Tail lamp, brake lamp, parking and
standing lamp
8
Turn signal lamp
Side marker lamp
X
Turn the bulb socket on backside of tail
lamp unit counterclockwise and remove
side marker lamp 3 with bulb socket.
X
Turn the new bulb with socket on backside
of tail lamp unit clockwise until it engages.
Other lamps
X
Depending on which bulb needs to be
replaced, press gently onto the respective
bulb and turn it counterclockwise out of its
bulb socket.
X
Gently press the new bulb into its bulb
socket and turn it clockwise until it
engages.
Reinstall bulb carrier
X
Reinstall the bulb carrier and let tabs 1
(Y page 358) engage.
X
Connect the electrical connector 2
(Y page 358) until it engages.
X
Reinstall trim panel.
Replacing wiper blades
Safety notes
G
Warning!
For safety reasons, switch off wipers and
remove SmartKey from starter switch
(vehicles with KEYLESS-GO: Make sure the
vehicle’s on-board electronics have status
0) before replacing a wiper blade.
Otherwise, the wiper motor could suddenly
turn on and cause injury.
G
Warning!
Wiper blades are components that are
subject to wear and tear. Replace the wiper
blades twice a year, preferably in the spring
and fall. Otherwise the windows will not be
properly wiped. As a result, you may not be
able to observe surrounding traffic
conditions and could cause an accident.
!
Never open the hood when a wiper arm is
folded forward.
Hold on to the wiper when folding a wiper
arm back. If released, the force of the
impact from the tensioning spring could
crack the windshield.
Practical hints
Z