Filter
Top Products
Panorama roof with power tilt/sliding panel
227
panel is blocked” section in this chapter for
details.
The opening/closing procedure of the tilt/
sliding panel can be immediately halted by
releasing the roof panel switch or, if the roof
panel switch was moved past the
resistance point and released, by moving
the roof panel switch in any direction.
G
Observe Safety notes, see
page 59.
G
Warning!
The panorama roof with tilt/sliding panel is
made out of glass. In the event of an
accident, the glass may shatter. This may
result in an opening in the roof.
In a vehicle rollover, occupants not wearing
their seat belts or not wearing them
properly may be thrown out of the opening.
Such an opening also presents a potential
for injury for occupants wearing their seat
belts properly as entire body parts or
portions of them may protrude from the
passenger compartment.
!
To avoid damaging the seals, do not
transport any objects with sharp edges
which can stick out of the tilt/sliding panel.
Do not open the tilt/sliding panel if there is
snow or ice on the roof, as this could result
in malfunctions.
!
Please keep in mind that weather
conditions can sometimes change rapidly.
Make sure to close the tilt/sliding panel
when leaving the vehicle. If water enters
the vehicle interior, vehicle electronics
could be damaged which is not covered by
the Mercedes-Benz Limited Warranty.
Roof panel switch
1
Raising
2
Opening
3
Closing
The tilt/sliding panel only operates with the
roller sunblinds retracted.
i
You can also open or close the tilt/sliding
panel using the SmartKey, see “Summer
opening feature” (Y page 111) or see
“Convenience closing
feature” (Y page 111).
X
Switch on the ignition.
Opening
X
Opening manually: Press and hold the
roof panel switch to the resistance point in
direction of arrow 2.
X
Release the roof panel switch when the
desired position is reached.
X
Express operation: To open the tilt/
sliding panel completely, press the roof
panel switch past the resistance point in
direction of arrow 2 and release.
X
Stopping during express operation:
Move the roof panel switch in any direction.
i
Express opening is not available when the
tilt/sliding panel is raised. The tilt/sliding
panel must be closed first.
i
When the tilt/sliding panel is open,
resonance noises may result in addition to
the usual wind noises. They are caused by
minimal pressure changes in the passenger
Controls in detail
Z