Filter
Top Products
Control system
147
X
Press # to change the current status.
Depending on the previous status, the
additional speedometer will be switched
On or Off.
Permanent display (vehicles with
automatic transmission)
You can use the Permanent Display function
to choose to display either the outside
temperature or the speed in kilometers (USA)
or miles (Canada) permanently.
X
Press % or $ to select the Instr.
Cluster submenu.
X
Press #.
X
Press % or $ to select Permanent
Display: function.
The current setting is shown.
X
Press # to change the current status.
Depending on the previous status, the
Permanent Display: will be switched
between Outside temperature or
Speedometer (km/h) (USA)/
Speedometer (miles) (Canada).
The selected display is then shown
continuously in the lower display.
Time/Date submenu
Access the Time/Date submenu via the
Settings menu. Use the Time/Date
submenu to change the time and date display
settings.
The following functions are available:
R
Setting the time (Y page 147)
R
Setting the date (Y page 148)
Setting the time
This function is not available if your vehicle is
equipped with the COMAND system and
navigation module.
Vehicles with COMAND system:
For information on setting the time in the
COMAND system, refer to the separate
COMAND system operating instructions.
X
Press % or $ to select the Time/
date submenu.
X
Press #.
X
Press % or $ to select the Time
function.
X
Press #.
The current time appears in the
multifunction display.
X
To set a new time press # again.
X
Press button ( or & to select the
setting you wish to change: hours or
minutes.
Controls in detail
Z