Mercedes-Benz 2009 C350 Sport Automobile User Manual


 
Driving instructions
286
Driving instructions
Drive sensibly – save fuel
To save fuel you should:
R
Keep tires at the recommended inflation
pressures.
R
Remove unnecessary loads.
R
Remove roof rack when not in use.
R
Allow engine to warm up under low load
use.
R
Avoid frequent acceleration and
deceleration.
R
Have all maintenance work performed at
the intervals specified in the Maintenance
Booklet and as required by the
Maintenance system. Contact an
authorized Mercedes-Benz Center.
Fuel consumption is also increased by driving
in cold weather, in stop-and-go traffic, on
short trips and in mountainous areas.
Drinking and driving
G
Warning!
Drinking and driving and/or taking drugs
and driving are very dangerous
combinations. Even a small amount of
alcohol or drugs can affect your reflexes,
perceptions and judgment.
The possibility of a serious or even fatal
accident are greatly increased when you
drink or take drugs and drive.
Do not drink or take drugs and drive or allow
anyone to drive who has been drinking or
taking drugs.
Pedals
G
Warning!
Make sure absolutely no objects are
obstructing the pedals’ range of movement.
Keep the driver’s footwell clear of all
obstacles. If there are any floormats or
carpets in the footwell, make sure that the
pedals still have sufficient clearance.
During sudden driving or braking
maneuvers, the objects could get caught
between the pedals. You could then no
longer brake or accelerate. This could lead
to accidents and injury.
Power assistance
G
Warning!
There is no power assistance for the
steering and the service brake when the
engine is not running.
Steering and braking requires significantly
more effort and you could lose control of
the vehicle and cause an accident as a
result.
Do not turn off the engine while the vehicle
is in motion.
Brakes
Downhill grades
!
When driving down long and steep
grades, relieve the load on the brakes by
shifting into a lower gear to use the
engine’s braking power. This helps prevent
overheating of the brakes and reduces
wear.
When using the engine’s braking power, a
drive wheel may not spin for an extended
period of time, e.g. on slippery road
Operation