Filter
Top Products
249
Control systems
COMAND vehicle menu
Extending or retracting rear window
sunshade
This function is used to extend or retract
the rear sunshade.
̈ Select “Vehicle”.
The main area is active.
̈ Selecting “Rear-window Sunshade”
function: Slide omp or rotate ymz.
̈ Extending or retracting rear window
sunshade: Press n.
or
̈ Select “Vehicle” Ǟ “Vehicle” Ǟ
“Rear-window Sunshade”.
̈ Confirming selection: Press n.
Trunk opening-height restriction*
on/off
Vehicles with trunk opening/closing sys-
tem*:
You can select whether the trunk lid should
open fully or only to the height of the roof.
̈ Select “Vehicle”.
The main area is active.
̈ Selecting “Trunk Opening-height Re-
striction” function: Slide omp or
rotate ymz.
̈ Confirming selection: Press n.
i
The components and operating principles of
COMAND can be found on (
୴ page 85).
i
If you operate the rear-window sunshade via
COMAND or by using the favorite button
(
୴ page 238), this takes precedence over the
buttons for the rear window sunshade in the rear
doors (
୴ page 503).
i
You can program this function using the fa-
vorite button (
୴ page 238).
i
At temperatures below -4°F (-20°C), the
rear window sunshade is switched off.
i
The components and operating principles of
COMAND can be found on (
୴ page 85).
୴୴