Filter
Top Products
599
Operation
Vehicle care
Ornamental moldings
For regular cleaning and care of ornamen-
tal moldings, use a damp cloth.
Headlamps, tail lamps, side markers,
turn signal lenses
̈ Use a mild car wash detergent, such as
Mercedes-Benz approved Car
Shampoo, with plenty of water.
Cleaning the DISTRONIC Plus*/
PRE-SAFE
®
Brake* system sensors
The sensors are integrated in the front
bumpers and cannot be seen from the
outside.
1 Sensor cover
2 Bumper area near sensors
̈ Switch off the ignition (୴ page 365).
̈ Use a mild car wash detergent, such as
Mercedes-Benz approved Car
Shampoo, with plenty of water and a
non-scratching cloth to clean sensor
cover 1.
i
After running the vehicle through an auto-
matic car wash, wipe any wax off of the wind-
shield (
୴ page 603). This will prevent smears
and reduce wiping noise which can be caused by
residual wax on the windshield.
When leaving the car wash, make sure that the
mirrors are folded out. Otherwise they may
vibrate.
!
Do not use chrome cleaner on ornamental
moldings. Although ornamental moldings may
have chrome appearance, they could be made of
anodized aluminum that will be damaged when
cleaned with chrome cleaner. Instead, use a
damp cloth to clean those ornamental moldings.
For very dirty ornamental moldings of which you
are sure are chrome-plated, use a chrome clean-
er. If in doubt whether an ornamental molding is
chrome-plated, contact an authorized
Mercedes-Benz Center.
!
Only use window cleaning solutions that are
suitable for plastic lamp lenses. Window clean-
ing solutions which are not suitable may damage
the plastic lamp lenses of the headlamps. There-
fore, do not use abrasives, solvents or cleaners
that contain solvents.
Never apply strong force and only use a soft,
non-scratching cloth when cleaning the lenses.
Do not attempt to wipe dirty lenses with a dry
cloth or sponge.
Otherwise you may scratch or damage the lens
surface.
୴୴