Filter
Top Products
251
Control systems
COMAND navigation system (destination memory)
̈ Destination memory list without in-
put characters: Press n immediately.
or
̈ Destination memory list with input
characters: Slide qm repeatedly until
the input characters disappear.
The list entry “My Address” is automat-
ically highlighted as long as you have
not entered any characters using the
input characters.
̈ If you have entered characters
from the list of input characters:
Rotate ymz or slide qm repeatedly
until the list entry “My Address” is
highlighted.
̈ Press n.
Further operation depends on whether you
want to enter the address manually or use
an address book entry as your own ad-
dress.
Entering an address manually
̈ If you want to assign your own ad-
dress for the first time: Select “Save
new entry”.
or
̈ If you want to change your own ad-
dress: Select “Change” Ǟ “Save new
entry”.
In both cases, the address input menu ap-
pears.
̈ Enter the address. Proceed as de-
scribed for destination entry in the “En-
tering a destination by address”
section (
୴ page 198).
̈ Select “Save” after entering the ad-
dress.
Your address is saved.
Using the address book entry as your
own address
̈ If you want to assign your own ad-
dress for the first time:
Select “Assign Address Book Entry”.
or
̈ If you want to change your own ad-
dress: Select “Change” Ǟ “Assign Ad-
dress Book Entry”.
In both cases, the menu appears for
searching for an address book entry.
̈ Select desired address book entry. Pro-
ceed as described in the “Searching for
an address book entry” section
(
୴ page 166).
Once the address data is complete and if it
matches the digital map data, COMAND
saves the entry as your own address in the
destination memory.
If address data is still missing or if it cannot
be found on the digital map, a message ap-
pears indicating that the address is incom-
plete.
୴୴