Filter
Top Products
209
Control systems
COMAND navigation system (entering a destination)
̈ Canceling selection: Select “Back”
and press n.
or
̈ Press back button L in the center
console (
୴ page 84).
̈ Confirming selection: Press n.
Streets with symbol 1 run through
several suburbs. Confirming one of
these streets takes you to a further
sub-selection.
If there are no other selection options,
the address input menu appears again
after the confirmation.
It shows one of the following items of infor-
mation:
ț Street and state (USA) or province
(CDN)
ț Street, city and state (USA) or province
(CDN)
Which of the following menu items are now
available depends on the situation, or may
depend on the data version of the digital
map. The menu items which are not avail-
able cannot be selected.
ț “Map”: using the map to enter a desti-
nation (
୴ page 221)
ț “House No.”: entering the house num-
ber (
୴ page 212)
ț “Intersection”: entering the intersec-
tion (
୴ page 215)
ț “POI”: entering a point of interest
(
୴ page 225)
ț “Save”: saving a destination in the des-
tination memory (
୴ page 247)
ț “Start”: starting the route calculation
(
୴ page 218)
̈ Continuing or completing destina-
tion entry: Select one of the menu
items mentioned above.
i
The city is visible if you have entered it be-
fore entering the street, or if COMAND can clear-
ly attribute the street entered to a city.
i
In this case, using the map for destination
entry is based on the city seen in the address in-
put menu.
i
Entering an intersection is restricted to
streets within the vicinity of the street entered.
i
In this case, entering a POI is based on the
city seen in the address input menu.