Filter
Top Products
241
Control systems
COMAND navigation system (during route guidance)
Displaying info
̈ Select “Info” in map view with the
menu system displayed (
୴ page 191).
The route information appears.
Example display with main destination and
stopover
1 Symbol = for stopover
2 Distance to the destination
3 Sequence of destinations (appears
with at least one stopover)
4 Street
5 City and abbreviation for province
(CDN) or state (USA)
6 Country
7 Symbol < for main destination
8 Estimated driving time to the destina-
tion
9 Estimated arrival time
i
COMAND uses the time set in COMAND as
the basis for calculating the estimated arrival
time. The clock must be set correctly in
COMAND (
୴ page 255). The calculation of the
estimated arrival time does not additionally take
into account whether Daylight Saving Time or
standard time is applicable at the destination. If
the destination is in a different time zone, arrival
time display
8 is in local time. This is indicated
by “LT” in the display.
The following data cannot be seen until the route
calculation has been completed:
ț Distance to destination 1
ț Estimated arrival time 8
ț Estimated remaining travel time 7
If the destination is located within a partially dig-
itized area, the following data may differ from the
facts:
ț Distance to destination 1
ț Estimated arrival time 8
ț Estimated remaining travel time 7