Filter
Top Products
199
Control systems
COMAND navigation system (entering a destination)
Menu items in the address input menu
Some menu items will not or not yet be
available, depending on the sequence in
which you enter the address and the data
version.
Example: If you have not made any entries,
menu items “House No.”, “Center”, “Inter-
section”, “POI”, “Start” and “Save” will not
yet be available. And the “Zip Code” menu
item will not be available if the digital map
does not contain any zip codes.
Entering a state (USA)
̈ In the address input menu, select
“State/Prov” Ǟ “States (U.S.)”.
A list of states appears with input char-
acters; the input characters are auto-
matically activated.
List of states with input characters
1 Top list entry based on the input data
up to that point
2 Characters entered by the user
3 Characters automatically added by the
system
4 Clear last character entry
5 Currently selectable characters
6 Currently non-selectable characters
7 Input characters
8 List of states
9 Currently selected characters
While the numbers are being selected as
described below, the top list entry 1 al-
ways shows the state which best corre-
sponds to the input data as it has been
entered up to that point.
At the same time, COMAND automatically
supplements characters 2 entered by the
user with other likely input characters 3.
̈ Selecting characters: Slide omp or
rotate ymz.
̈ Confirming character selection:
Press n.
̈ Deleting individual characters:
Select ) in the bottom line and
press n.
̈ Deleting an entire entry: Select ) in
the bottom line and press n until the
entire entry is deleted.
i
You can only enter those states which are
saved on the digital map.
i
In the list of input characters 7, you can
only select currently selectable characters.
Which characters are included depends on the
sequence in which you have entered your desti-
nation and the data version of the digital map.
୴୴