Filter
Top Products
108
Control systems
COMAND satellite radio
Tuning in channels
You have the following selection options:
ț The channel search function
ț The channel presets
ț The manual channel number entry
ț The channel list
Tuning in channels using channel
search function
̈ Slide omp or rotate ymz when the
main area is selected.
Depending on the direction in which
the controller is being pressed or rotat-
ed, the system searches upward or
downward and stops at the next receiv-
able channel.
Tuning in channels using channel
presets
̈ Select “Audio” Ǟ “Audio” Ǟ “Sat Ra-
dio” Ǟ “Presets”.
or
̈ Press n when the main area is select-
ed.
The preset menu appears. The dot R
in front of a preset position indicates
that this is the channel currently select-
ed and being listened to.
̈ Select station preset and briefly
press n.
or
̈ Enter a position number with the tele-
phone keypad using digits 1 to 9
(
୴ page 86).
COMAND tunes in the corresponding
channel as long as it is included in your
subscription and is still available.
If the channel is not included in your sub-
scription, you will see the message de-
scribed in the section “Satellite radio
service is not activated” (
୴ page 106).
i
This function is not possible when only the
preview channel is activated. If you try to tune in
a channel in this instance, you will see the
screen described in the section “Satellite radio
service is not activated” (
୴ page 106).
i
Which channels are found by the channel
search function depends on which channels you
have subscribed to and the program category
you have selected (
୴ page 107).