Filter
Top Products
109
Control systems
COMAND satellite radio
If the channel is no longer available or only
the preview channel is activated, you will
see the message “Invalid Channel”.
̈ Closing message: Press n.
Tuning in channels using manual chan-
nel number entry
Entering the channel number using the
COMAND controller
̈ Select “Audio” Ǟ “Audio” Ǟ “Sat Ra-
dio” Ǟ “Sat Radio” Ǟ “Channel Entry”.
The menu for manual channel number
entry appears.
̈ Exiting menu without making an en-
try: Press L back button in the cen-
ter console (
୴ page 84).
̈ Increase or decreasing number:
Slide qmr or rotate ymz.
̈ Selecting next number: Slide omp.
̈ Confirming channel entry: Press n.
Further operation depends on whether
the selected channel number is valid or
if the channel is included in your sub-
scription.
Entering the channel number using the
telephone keypad
̈ Press > on the telephone keypad
(
୴ page 86).
̈ Enter channel number using the R -
9 buttons.
Further operation depends on whether
the selected channel number is valid or
if the channel is included in your sub-
scription.
Channel number is valid and channel is
included in subscription
COMAND tunes in the channel entered.
Channel number is invalid
You will see the message “Invalid Chan-
nel”.
̈ Closing message: Press n.
Channel number is valid but channel is
not included in subscription
You will see the screen described in the
section “Satellite radio service is not acti-
vated” (
୴ page 106).
̈ Closing display: Press n.
i
This function is not possible when only the
preview channel is activated. If you try to tune in
a channel in this instance, you will see the
screen described in the section “Satellite radio
service is not activated” (
୴ page 106).