Filter
Top Products
196
Control systems
COMAND navigation (introduction)
Switching the geo-coordinate display on
or off
̈ Select “Navi” Ǟ “Navi” Ǟ “Map Dis-
play”.
The map display list appears.
̈ Select “Coordinates”.
The geo-coordinate display is switched
on or off, depending on the previous
status. A checkmark indicates which
status is active.
̈ Exiting menu: Slide omp or press
back button L in the center console
(
୴ page 84).
Setting route type
You can set the following route types:
ț “Fast Route”: COMAND calculates a
route with the shortest possible (mini-
mized) driving time.
ț “Short Route”: COMAND calculates a
route with the shortest possible (mini-
mized) distance taking distance and
driving time into account.
̈ Select “Navi” Ǟ “Navi” Ǟ “Mode”.
The mode list appears. A square ½ indi-
cates the current setting.
̈ Select route type: “Fast Route” or
“Short Route”.
̈ Exit menu: Slide omp or press back
button L in the center console
(
୴ page 84).
Setting route mode
̈ Select “Navi” Ǟ “Navi” Ǟ “Mode”.
The mode list appears.
̈ Switching mode on or off:
Select desired modes.
Depending on the previous status, the
mode is switched on or off. A check-
mark indicates that the mode is
switched on. It is possible to switch on
more than one mode.
i
If you change the route type setting during
active route guidance, COMAND calculates a
new route. If you change the setting when route
guidance is inactive, COMAND uses the new set-
ting for the next route guidance.
i
This function allows you to set the following
options for route guidance:
ț “Minimize Highways”
ț “Minimize Toll Roads”
ț “Minimize Tunnels”
ț “Minimize Ferries/Motorail”