Lowrance electronic LMS-525C DF GPS Receiver User Manual


 
221
Suzuki Engine Interface Configuration
To input Device Name:
1. Press MENU| MENU, use to select NMEA 2000 and press ENT. The
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
BUS SETUP and press ENT, which will open the Bus Configu-
ration menu. A list of network devices will be at the top of the page.
3. Use to select the engine interface you want to rename and press
ENT. The Device Configuration menu will appear with the Device Name
dialog box highlighted.
4. Press
ENT and use , to input a name for the interface. Press
ENT. Press EXIT repeatedly to return to the main display.
To select a Location:
1. Press MENU| MENU, use to select NMEA 2000 and press ENT. The
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
BUS SETUP and press ENT, which will open the Bus Configu-
ration menu. A list of network devices will be at the top of the page.
3. Select the desired engine interface and press
ENT. The Device Con-
figuration menu will appear.
4. Highlight
LOCATION and press ENT, which will open the Location menu
with the following options: Port, Center, Starboard and Unknown.
5. Select the desired location and press
ENT. The following confirmation
message will appear: Are you sure you wish to change this device's con-
figuration?
6. Press
ENT. Press EXIT repeatedly to get back to the main display.
To select Engine Type:
1. Press MENU| MENU, use to select NMEA 2000 and press ENT. The
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
BUS SETUP and press ENT, which will open the Bus Configu-
ration menu. A list of network devices will be at the top of the page.
3. Use to select the desired engine interface and press
ENT. The De-
vice Configuration menu will appear.
4. Highlight
ENGINE TYPE and press ENT, which will open the Engine
Type menu with the following options: DF40, DF50, DF60, DF70,
DF90/115, DF140, DF150, DF175, DF200/225, DF250 and DF300.