Filter
Top Products
131
By default, the trail flashes once a second, making it easier to see against
the background map. With the default auto setting, this unit creates a
trail by placing a dot (trail point) on the screen every time you change di-
rections. (The methods used for creating a trail and the trail update rate
can both be adjusted or even turned off. See Sec. 8 for Trail Options.)
To preserve a trail from point A to point B, you must "turn off" the trail
by making it inactive before heading to point C or even back to point A.
When the current trail is set inactive, the unit automatically begins
recording a new trail.
Sequence for saving a trail and beginning a new one. Left, My Trails
command. Center, the Trails Menu. The arrow to the right of Trail 1
indicates the trail is "active," and the check to the left indicates the
trail is visible on the map display. The right figure shows the Edit
Trail menu, with the Active command selected.
To Save a Trail
1. Press
MENU|MENU|↓ to MY TRAILS|ENT.
2. Press ↓ to the Active Trail Name|
ENT.
3. Press ↓ to
ACTIVE|ENT. This unchecks the Active option.
4. To return to the previous page, press
EXIT repeatedly. As you leave
the Edit Trail menu, you will notice that a new trail starts with a new
sequential number. In the example figure below, the new trail is num-
ber 2, showing zero points. Note that Trail 1 is inactive, but it is still
visible on the map.
Active
symbol
Visible
symbol