Filter
Top Products
214
The second tab at the top of the NMEA 2000 Alarms page is the Alarm
Status Tab. When an alarm has been set for a device, the alarm and its
current status will be shown on the Alarm Status window. To view the
Alarm Status window, highlight the Alarm Status tab and press
ENT.
To set NMEA 2000 Alarm:
1. Press MENU|MENU, select NMEA 2000 and press ENT.
2. Highlight
NMEA 2000 ALARMS and press ENT.
3. Highlight
FLUID LEVEL DEVICE and press ENT. Use ↑ ↓ to select the de-
vice you want to set an alarm for and press
ENT.
4. Highlight the
ENABLED box next to the desired alarm (Full Alarm or
Empty Alarm) and press
ENT to turn on the alarm.
5. To set the alarm percentage, press → to highlight
PERCENT and press
ENT.
6. Use ↑ ↓, ← → to input the desired percentage and press
ENT. Repeat
Steps 3-4 to set the other alarm.
7. Highlight
SET CONFIGURATION and press ENT to finalize alarm settings.
Press
EXIT repeatedly to get back to the main display.
NOTE:
To turn off (uncheck) an alarm, highlight its ENABLED BOX and press
ENTER.
Waypoint Sharing
Waypoint Sharing allows you to share a waypoint from one display unit
with display units across the network.
To turn on/off Waypoint Sharing:
1. Press
MENU|MENU, select NMEA 2000 and press ENT.
2. Highlight
WAYPOINT SHARING and press ENT which will turn on/off way-
point sharing.
3. Press
EXIT repeatedly to get return to the main display.
Backlight Synchronization
The Backlight Synchronization command will keep all display unit
backlight levels consistent across the NMEA 2000 network. So, if you
set the backlight level to 75% on one display unit, all other units on the
network will automatically switch to the same setting.